Fan Cycle Information - GE Profile J2S968 SERIES Technical Service Manual

Convection Fan Assemblies
The convection fan assembly consists of the fan guard, element (Dual Fuel Range), fan blade, and
motor. It is located on the back wall of the oven.
Refer to the schematic in the back of this manual for circuitry for your specific model.
Note: The JGSP48 All Gas Range models do not have convection fans.
Dual Fuel Range Convection Fan Assembly
OVEN
INSULATION
n
OVEN
LINER
ELEMENT
FAN
E
BLADE NUT
b
SCREWS
e
(4)
v
t

Fan Cycle Information

All times are in seconds.
Convection Fan Operation - All times are in seconds
Dual Fuel
Convection Bake
Single rack
Convection Bake
Multi rack
Convection Roast
All Gas
The convection fan will not come on while there is a call for heat from the thermostat (gas burner on).
Fan will only start to operate 10 seconds after the burners turn off.
The fan will only run in one direction with the following parameters:
Convection Bake
Convection Roast Continuously
CONV.
OUTER
FAN
BACK
MTG.
PANEL
SCREWS
(3)
CONV.
FAN
SUPPORT
OVEN
CAVITY
MOUNTING
FAN SCREWS
(3)
BLADE
CW Rotation Pause/Off
180
20
0
High Speed Low Speed
3
All Gas Range Convection Fan Assembly
A
OVEN
INSULATION
OVEN
LINER
FAN
BLADE NUT
SCREWS
(4)
CCW Rotation
10 180
30 40
0 Continuously
Pause/Off
7 50
0 0
– 33 –
CONV.
OUTER
FAN
BACK
MTG.
PANEL
SCREWS
(3)
CONV.
FAN
SUPPORT
OVEN
CAVITY
FAN
MOUNTING
SCREWS
BLADE
(3)
Pause/Off
10 Repeat
30 Repeat
0
Repeat