GE Profile J2S968 SERIES Technical Service Manual page 29

3. Remove the 4 screws that hold the burner
baffle in place.
Burner Baffle
4. Remove the 2 screws that hold the burner in
place.
5. Remove the screw that holds the orifice fitting
cover in place. Remove the fitting cover.
Orifice Fitting
Bake Burner
6. Remove the 2 hex-head screws that hold the
glow-bar igniter to the bake burner.
Cover
7. Remove the bake burner.
Note: When reinstalling the broil burner, make
sure the burner inlet opening is over the gas
outlet.
Slot
Tab
8. Gently pull the glow-bar connector through the
oven wall. Disconnect the glow-bar igniter
wires.
6. Remove the glow-bar igniter from the oven.
IMPORTANT: When reinstalling the glow-bar, the
connector end must be positioned OUTSIDE the
range insulation. Do not allow the connector next
to or inside the insulation. Allow the stiff over
sleeve to position the connector away from the
insulation.
Insulation should be allowed to close in around the
igniter lead wires thus protecting the connector
from any heat loss at the insulation opening.
– 29 –
Burner Gas Outlet
Burner Inlet Opening
Disconnect