GE Profile J2S968 SERIES Technical Service Manual page 35

6. Disconnect the wiring harness connector
from the motor.
7. Remove the 3 mounting hex-head screws and
the motor.
Dual Fuel Range Fan Motor
Disconnect
The dual fuel convection fan motor has an
approximate resistance value of 58 Ω.
All Gas Range Fan Motor
Disconnect
The all gas convection fan motor has an
approximate resistance value of 19 Ω - 25 Ω.
Note: Make sure the anti-tip bracket is installed
correctly when pushing the range back into place.
Dual Fuel Range Convection Fan Circuit
L1
L1
2
All Gas Range Convection Fan Circuit
L1
Disconnect
If convection fan is not working, make the
following checks:
• Check the voltage from terminal (CF) to (N) on
control—it should read 120V in Convection
Bake or Roast mode. If not, replace the
control.
• If voltage is OK, check the convection fan
motor. It reads approximately 15 Ω to 20 Ω at
room temperature. Check to make sure the
fan shaft is not rubbing on the oven liner.
– 35 –
CONVECTION BAKE
240V.
L-1
10.4A
CONV-1
CONVECTION
BAKE ELE.
2500W
CW
L1-1
CONVEC CCW
CONVECTION
CONVECTION ROAST
240V.
L-1
15A
BROIL-1
BROIL
4000W
14.4A
CW
L1-1
CONVEC CCW
CONVECTION
CONVECTION BAKE
LOW SPEED
DBL RELAY
HI SPEED
L2
DLB
10.4A RELAY
N
NO C
DOOR
SW
FAN
L2
DLB
15A RELAY
N
NO C
DOOR
SW
FAN
N
CONVECTION
FAN