Oven Gas Shut-Off Valve (All Gas); Oven Light Bulbs - GE Profile J2S968 SERIES Technical Service Manual

Oven Light Bulbs

Receptacle
Glass cover
Caution: Before replacing your oven light bulb,
disconnect the electrical power to the oven at the
main fuse or circuit breaker panel.
Note: The glass cover should be removed only
when cold. Be sure to let the light cover and bulb
cool completely. Do not touch a hot bulb with bare
hands or a damp cloth.
Replace with a new 130V halogen bulb, not to
exceed 50 watts.
If oven light is not working, make the following
checks:
• Check oven light bulb.
• Light should come on when door is opened -
check voltage across light socket terminals. It
should read 120 VAC. If 0 volts, check jamb
switch and wiring.
To remove and replace the oven light bulb:
1. Turn the glass cover counterclockwise
until the tabs of the glass cover clear the
grooves of the socket.
2. Using gloves or a dry cloth, remove the bulb
by pulling it straight out.
3. Using gloves or a dry cloth, remove the new
bulb from its packaging. Do not touch the
bulb with bare fingers. Push the bulb
straight into the receptacle all the way. Place
the tabs of the glass cover into the grooves of
the socket. Turn the glass cover clockwise
turn to engage.
Socket
Bulb
Tab
x.
.
1 / turn
4
1 /
4
– 26 –
4. For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth.
This should be done when the oven is
completely cool.
5. Reconnect electrical power to the oven.

Oven Gas Shut-off Valve (All Gas)

The gas shut-off valve is located on the side of the
pressure regulator which is mounted on a bracket
behind the storage drawer. Access to the shut-off
lever is obtained by removing the storage drawer
and reaching through the opening.
Note: The oven shut-off valve shuts off the gas to
the oven only and has no effect on the top
burners.
Shut-Off Lever
Shown in the
Open Position
Pressure Regulator as Seen
Pressure Regulator
from Front of Range
as see from Front of
Range
Gas Supply
to Oven
Gas Supply to
Top Burner