Connecting Local I/O Devices; Using The Local I/O Cable; Connecting To A Server Blade Through Ilo - HP ProLiant BL30p Setup And Installation Manual

Using the Local I/O Cable

Use the local I/O cable to perform some server blade configuration and diagnostic
procedures.

Connecting to a Server Blade through iLO

To connect directly to iLO using the local I/O cable, you must have the following:
•
A client PC with a 10/100 Ethernet RJ-45 connector
•
A network cable with RJ-45 connectors
To connect directly to iLO:
IMPORTANT: Do not connect the local I/O cable to a hub when connecting to iLO. All server
blades have the same IP address through the I/O port. Multiples on a hub make the server
blades indistinguishable on the network. Refer to "Integrated Lights-Out Advanced
Management" in Chapter 5, "Server Blade Configuration and Utilities," for the default server
blade IP address.
HP ProLiant BL30p Server Blade Setup and Installation Guide

Connecting Local I/O Devices

6
6-1