Powering Down The Server Blade - HP ProLiant BL30p Setup And Installation Manual

Server Blade Operations
•
Virtual power button features through the iLO remote console
— A momentary power-up selection
— A hold power-up selection
For more information about iLO, refer to Chapter 5, "Server Blade Configuration and
Utilities."

Powering Down the Server Blade

The ProLiant BL30p server blade can be powered down in either of the following
ways:
— Use the virtual power button feature in the iLO remote console to power
down the server blade. Be sure that the server blade is in standby mode by
observing that the power LED is amber. For iLO information and procedures,
refer to the HP Integrated Lights-Out User Guide.
— Press the power button on the front of the server blade. Be sure that the
server blade is in standby mode by observing that the power LED is amber.
This process may take 30 seconds, during which time some internal circuitry
remains active.
IMPORTANT: To remove power completely from the server blade, remove the server blade
from the server blade enclosure.
IMPORTANT: Be sure that the server blade has the most recent firmware for the power
enclosure and server blade enclosure management modules. For the most recent firmware,
refer to http://welcome.hp.com/country/us/en/support.html.
2-2 HP ProLiant BL30p Server Blade Setup and Installation Guide