HP ProLiant BL30p Setup And Installation Manual page 99

Clearing the System Configuration
To clear the system configuration:
1. Power down the server blade:
a. Press the Power On/Standby button on the front of the server blade.
b. Use the virtual power button feature in the iLO remote console.
2. Disconnect the server blade from all power sources:
a. Remove the server blade from the server blade enclosure and set it on a flat,
level surface.
b. Disconnect the server blade from the diagnostic station.
3. Change position 6 of SW1 to on.
4. Install the server blade into the server blade sleeve and connect the server blade
to system power:
a. Install the server blade in the server blade enclosure.
b. Connect the server blade to the diagnostic station.
5. Power up the server blade:
a. Press the Power On/Standby button on the front of the server blade.
b. Use the virtual power button feature in the iLO remote console.
6. Wait for the POST message that prompts you to change the switch setting:
Maintenance switch detected in the "On" position.
Power off the server and turn switch to the "Off" position.
7. Repeat steps 1 and 2.
HP ProLiant BL30p Server Blade Setup and Installation Guide
Server Blade Troubleshooting
A-17