HP ProLiant BL30p Setup And Installation Manual page 66

Server Blade Configuration and Utilities
Enable iLO IP Address Assignment
Bay #1 through Bay #16 checkboxes allow you to select which BL p-class server
blades will be configured. You may Enable All, Clear All, or Apply the selection.
Moving the Server Blade or Downgrading the iLO Firmware
If it becomes necessary to move the server blade to a new enclosure, or change the
iLO firmware, the following can occur:
•
If the rack does not support Static IP Bay Configuration and Static IP Bay
Configuration is enabled, the server blade will revert to DHCP addressing
automatically.
•
If the server blade is downgraded with Static IP Bay Configuration enabled, the
IP address setting will become static. If you want to use DHCP, you must re-
enable DHCP through the iLO web interface or use an XML script.
Remote Insight Command Language
Several new XML commands have been added to the Remote Insight Command
Language (RIBCL) structure to support reading and writing of Static IP Bay
Configuration in scripting. The new RIBCL commands must be scripted within a
RACK_INFO command block. The new attributes are:
•
MOD_ISIP_SETTINGS modifies the Static IP Bay Configuration settings. This
command is only valid inside a RACK_INFO block. The logged-in user must
have the configure iLO privilege. This attribute must appear inside the
RACK_INFO command block with MODE = "write."
•
SLOT_ENABLE MASK enables the use of Static IP Bay Configuration
addressing. The attribute MASK is a 16-bit number. Each bit represents a slot in
the enclosure. If the bit is set, that particular slot will be assigned to use the Static
IP Bay Configuration settings. The least significant bit (LSB) represents slot 1.
For example, the MASK="0x0001" will only allow slot 1 to use Static IP Bay
Configuration. This number can be either a hexadecimal number or a decimal
number. This command must appear inside the MOD_ISIP_SETTINGS block.
5-24 HP ProLiant BL30p Server Blade Setup and Installation Guide