Earpiece Volume; Vibrate Mode; Using The Handset - Vertical SBX IP 320 User Manual

Using Your DECT Cordless Handset

Earpiece Volume

During a call ... press TALK then press the vol /
button on the side of the handset to select the earpiece
volume of the handset.

Vibrate Mode

Selecting the (Ringer
into Vibrate Mode.
If you set the
there is an incoming call.
If you set the
- Low.

Using the Handset

When you pick up the handset and press TALK, the
"ACQUIRING LINK" message appears as shown on the right.
After the connection has been made between the handset
and base unit, the TALK
The screen goes into standby mode and the telephone is
ready to use.
If the handset is at the range limit of the DECT Cordless
Telephone, or no power is going to the base unit, you may
see the "Out Of Range" message as shown on the right.
Take the following action:
During a Call ...
The sound is muted.
Action --> Move back in range within 20
seconds or check power to the base unit.
Release 2.0
Off) setting shown above,
and the Handset is not on the charger, the Handset will vibrate when
and the Handset is on the charger, the Handset will ring as Ring Type
icon appears on the display.
DECT Cordless Telephone User Guide
/
places the DECT Cordless Telephone
In Standby Mode ...
You can not make or answer a call (telephone
may ring intermittently).
Action --> Move back within range, or check
the power to the base unit.
15
October 2010