Figure 3-27 A 5-Wire Connector - HP A9834-9001B User's & Service Manual

Installing the System
Setting Up the System
Figure 3-27 A 5-Wire Connector
L3 N
L2 L1 PE
Use the following procedure to install the PDCA:
Make sure the circuit breaker on the PDCA is OFF.
WARNING
Step 1. Remove the rear PDCA bezel by removing the four retaining screws.
Step 2. Run the power cord down through the appropriate opening in the floor tile.
Step 3. Insert the PDCA into its slot and secure with four screws (Figure 3-28 on page 106).
105
Chapter 3