Parallel Ringing - Aastra DT390 User Manual

DT390
5.1.3 Mute ring signal temporarily
If the phone rings at an inconvenient moment:
1. Press
All alert signals, including the vibrator, will silence for this specific call.
2. Press
5.1.4 Switch Ring Signal off
You can set your phone to silent ringing, when your phone is in idle mode:
•
5.1.5 Reject the Call
If you do not want to take the call, when the phone rings:
•
5.1.6 End the call
To end a call:
•
5.2

Parallel Ringing

The Parallel Ringing function makes it possible for an incoming call to ring
several phones simultaneously and for the call to be answered on any of
the phones. The main advantage of this function is minimizing the risk of
losing calls. The function requires all the phones involved to be defined in a
Parallel Ringing list, which must be configured and initiated by your system
administrator. Because only calls to a main extension will be distributed among
the phones in the list, this main extension also needs to be defined. A call to
a specific extension will not be distributed to other phones in the list, and will
only ring that specific extension's phone. Parallel Ringing can be temporarily
disabled by the phone user using the function Internal Follow-me. For more
information on Internal Follow-me, see Section 9.2 on page 51.
28
to suppress the ringing.
to answer the call.
Press to switch the ring signal on or off. When switched off,
shown. All alert signals will silence until the ring signal is switched on again.
If the vibrator is set to On when silent, it will alert you of new calls. See
Section 14.1.3 on page 71.
Press to reject the call.
The call is disconnected.
Press .
The display shows the duration of the call. The total time of the call can
also be retrieved from the calls tab.
1424-EN/LZT 103 087 Uen A3 2008-11-21
is