Table of Contents
Advertisement
9
CONNECTIONS AND MAINTENANCE
■ UT-112/UT-98 installation (Continued)
r Return the cables and screws to the original position.
• Be sure the flat cable is not installed upside down.
CAUTION:
• When re-assembling the case and tightening the screws,
you must keep the specified torque (0.5±0.07 N•m). Oth-
erwise, the transceiver may be damaged (torque too
high) or lose waterproof efficiency (torque too low).
• When uninstalling the optional unit, remove it vertically.
Wiggling the unit from side to side may damage the con-
nector.
62
■ Microphone installation
HM-126*
The supplied/optional HM-126* and optional HM-157 can
be connected to the transceiver directly, as well as using the
long connection cable that comes with the microphone.
The connection cable is used for a longer distance remote
operation, and the cable connector can be installed into a
cabinet, wall, etc., as a built-in plug.
* Not supplied with some versions.
The optional HM-162 should be attached to the transceiver
using the connection cable that comes with the micro-
phone.
HM-157
HM-162
Advertisement
Table of Contents
