Dry Cycles - GE Profile PFDS450 Owner's Manual & Installation Instructions

Table of Contents

Advertisement

Available languages

Available languages

About the dryer control panel.

Dry Cycles

The dry cycle controls the cycle time for the drying process. The chart below will help you match the dry setting with the
loads.
2
Sensor Cycles
COTTONS
NORMAL/
MIXED LOAD
WRINKLE FREE
ACTIVE WEAR
technology finishes and stretch fibers such as Spandex.
DELICATES
SPEED DRY
used if the previous cycle left some items damp, such as collars or waistbands.
Timed Dry Cycles
STEAM
REFRESH
(on some models)
DEWRINKLE
(on some models)
STEAM
DEWRINKLE
(on some models)
WARM UP
My Cycle (on some models)
MY CYCLE
3
Timed Dry
Use to set your own dry time. TIMED DRY is also recommended for small loads.
To use TIMED DRY:
1. Turn dry cycle dial to TIMED DRY.
2. Select the drying time by pressing the
3. Select the DRY TEMP.
4. Close the door.
5. Press START/PAUSE.
4
Sensor Dry
The sensor continuously monitors the amount of moisture in the load. When the moisture in your clothes reaches your selected dry level, the dryer will stop.
EXTRA DRY
MORE DRY
DRY
LESS DRY
DAMP
6
Downloaded from
www.Manualslib.com
For cottons and most linens.
For loads consisting of cottons and poly-blends.
For wrinkle-free/easy care and permanent press items.
Clothing worn for active sports exercise and some casual wear. Fabrics include new
For lingerie and special-care fabrics.
For small loads that are needed in a hurry, such as sports or school uniforms. Can also be
For slightly wrinkled dry garments. Significantly reduces wrinkles on 1–5 garments.
Selecting a higher number of garments for the cycle (e.g., selecting 5-garment load for a 1-garment load) may result in excessive wetting
of clothes. After the STEAM REFRESH Cycle, the unit will beep and display "Garments Ready" and "0:00." If the unit is not turned off or if the
door is not opened, the dryer will continue to tumble for 30 minutes. At the end of 30 minutes, it will display "0:00" and "Cycle Complete."
NOTE: When STEAM REFRESH is selected, "EXTENDED TUMBLE" will automatically turn on and cannot be turned off.
A single extremely light fabric item may need to have an additional item included in the steam refresh cycle to achieve optimum results.
For removing wrinkles from items that are dry or slightly damp. This cycle is not reccomended for delicate
fabrics.
For use with larger loads than STEAM REFRESH. Ideal for loads left in dryer for an extended
time. Selecting a larger cycle than needed (e.g., selecting Large Load for a half-full dryer)
may result in excessive wetting of clothes.
Provides 10 minutes of warming time to warm up clothes.
Press to use, create or modify custom dry cycles.
and
buttons. You can increase the time in 10-minute increments up to 2 hours, 5 minutes.
Use for heavy-duty fabrics or items that should be very dry, such as towels.
Use for heavy or mixed type of fabrics.
Use for normal dryness level suitable for most loads. This is the preferred cycle
for energy saving.
Use for lighter fabric (ideal for ironing).
For leaving items partially damp.
manuals search engine

Advertisement

Table of Contents
loading

Table of Contents