GE Profile PFDS450 Owner's Manual & Installation Instructions page 37

REVERSE DOOR HANDLE AND CAPS
3
(CONT.)
E Reassemble the outer handle to the inner handle,
using 3 screws (#8 x 0.625" tapping screws).
Outer
handle
F Assemble the new right-side door cap (from
reversibility kit), using 2 screws (#8 x 0.625" tapping
screws).
2 x D Screws
Door cap
Put the chrome cover aside on a soft, protected
flat surface.
REVERSE HINGE AND CAPS
4
• Lay the inner door down on a soft , protected
flat surface so that the inner part faces down.
Disassemble the outer window by opening 2 snaps,
lay the outer window on a soft, protected flat
surface.
• Disassemble the inner cover (mask) by opening
2 snaps, lay the inner cover (mask) on a soft,
protected flat surface.
Downloaded from www.Manualslib.com
Installation Instructions
3 x D
Screws
(inner
handle)
manuals search engine
REVERSE HINGE AND CAPS (CONT.)
4
Outer window
Inner cover
(Mask)
• Turn the inner door on a soft , protected flat
surface so that the inner part faces up.
• Remove the screws, nuts and washers on the
opposite side of the hinge, using a quadrex
screwdriver.
• Disassemble the inner door cap from the inner
door by removing 2 screws (#8 x 0.75" tapping
screws).
• Disassemble the hinge from the inner door by
removing 4 screws (#8-32 x 0.50" machine screws).
Remove
4 x E screws
Hinge
37
Snap
Snap
Inner
door cap
2 screws,
2 x D
2 nuts and
Screws
2 washers