GE Profile PFDS450 Owner's Manual & Installation Instructions page 44

2 PREPARE THE PEDESTAL
Pull the drawer
A
out as far as it
will go.
Remove
B
screws from
drawer slides.
Slide drawer
out of the
base and set
aside.
FOR DRYERS ONLY:
Locate the 4 support pads from the parts
C
package. Each pad has 2 protrusions that fit
into the holes on top of the pedestal. Press the
rubber pads into each set of corner holes on
the top of the pedestal as shown.
NOTE: The support pads should be installed on the
dryer only. DO NOT INSTALL THESE PADS ON THE
WASHER PEDESTAL.
Downloaded from www.Manualslib.com
Installation Instructions
manuals search engine
3 INSTALL THE PEDESTAL TO THE
WASHER OR DRYER
Place the pedestal against the bottom of the
A
unit. Check to be sure the drawer front is at the
front of the washer.
Align the holes in the pedestal with the holes in
B
the bottom of the unit. Use a Phillips screwdriver
to install the 4 bolts through the pedestal and
Slide the pedestal toward the unit, until it is
C
aligned front to back. Use a 7 mm socket
wrench to securely tighten the bolts.
44