GE Profile PFDS450 Owner's Manual & Installation Instructions page 38

REVERSING THE DOOR SWING (if desired)
REVERSE HINGE AND CAPS (CONT.)
• Assemble the hinge to the opposite side of the
inner door, using 4 screws (#8-32 x 0.50" machine
screws).
• Assemble the new inner door cap (from reversibility
kit) on the opposite side of the hinge, using 2
screws (#8 x 0.75" tapping screws).
• Install the the screws, nuts and washers on the
opposite side of the hinge in the 2 remaining holes.
• Flip the inner door so that the inner part faces down.
Replace
2 x D
screws
Inner
door
cap
Assemble the inner cover (mask), be sure the snaps
have clamped the inner cover. Assemble the outer
window, be sure the 2 snaps have clamped the outer
window.
Outer window
Downloaded from www.Manualslib.com
Installation Instructions
Replace
Replace
4 x E
2 screws,
screws
2 nuts and
2 washers
Snap
Inner cover
(Mask)
Snap
manuals search engine
REASSEMBLE DOOR ASSEMBLY
5
Turn the inner door over
and place on a soft,
protected flat surface
so that the inner part is
facing down. Assemble
the chrome cover to the
inner door by placing
them together. Flip the
door assembly over and
assemble, using 7 screws
(#10 x 1.125" tapping
screws).
Hinge
REVERSE FRONT PANEL PLUG
6
BUTTONS AND STRIKE PLATE
Remove the 2 plug buttons on the dryer front
panel, using a putty knife or other flat tool as
shown, and reinstall on the opposite side. Switch
the strike bracket and its cover by removing 2
screws (#8 x 0.625" tapping screws) for each and
reinstalling on opposite sides.
2 Plug
buttons
NOTE: Apply a protective piece of tape to the side
of the plug button where the putty knife blade will
be inserted to prevent scratching.
38
7 x A Screws
Protective
piece of tape
Strike
bracket