GE Profile PFDS450 Owner's Manual & Installation Instructions page 7

Dry Temp
5
You can change the temperature of your dry cycle.
ANTI-BACTERIAL
HIGH
MEDIUM
LOW
EXTRA LOW
START/PAUSE
6
Press to start a dry cycle. If the dryer is running, press it once and it will pause the dryer. Press it again to resume the dry
cycle.
7
M
Y
C
YCLE
S M C
TORE Y YCLE
To store a MY CYCLE combination of settings:
1. Select your drying cycle.
2. Change DRY TEMP and SENSOR DRY settings to fit your needs.
3. Select any drying OPTIONS you want.
4. Press and hold the MY CYCLE button for 3 seconds to store your selection. A beep will sound the button will light up, and
the unit will display "My cycle is now programed with the current cycle settings".
To recall your stored MY CYCLE combination:
Press the MY CYCLE button before drying a load. The light in the center of the button will light up when MY CYCLE is selected.
To change your stored MY CYCLE combination:
Follow Steps 1–4 in "To store a MY CYCLE combination of settings."
8
Display
Special Cycle Status OR
Dryer Rack OR Timed Dry
"CLEAN LINT FILTER" (message)
This message appears periodically. It is only a reminder.
Downloaded from www.Manualslib.com
This option may only be used with COTTONS or MIXED LOAD cycles. This option reduces certain types of bacteria by
99.9%, including: Staphylococcus aureus, Pseudomonas aeruginosa and Klebsiella pneumoniae*. The anti-bacterial
process occurs when high heat is used during a portion of this drying cycle.
NOTE: Do not use this cycle on delicate fabrics.
* The Anti-Bacterial Cycle is Certified by NSF International (formerly National Sanitation Foundation) to NSF Protocol
P154 Sanitization Performance of Residential Clothes Dryers.
For regular to heavy cottons.
For synthetics, blends and items labeled permanent press.
For delicates, synthetics and items labeled Tumble Dry Low.
For lingerie and special-care fabrics.
My Cycle
(on some models)
Set up your favorite combination of settings and save them here for one touch recall. These custom
settings can be set while a cycle is in progress.
Est. Cycle Time
OR Time to Dry
SPECIALTY CYCLE
Comforters
S
PECIALTY
C
Delay Time
YCLES
Clean Lint Filter
Delay Time Lint Filter Status
Status Screen
manuals search engine
0 1:10
ENTER
1:00
DELAY TIME
After the POWER button is pressed, the CLEAN
LINT FILTER message could appear if the
previous cycle was not finished. This message
will disappear after the START button is pressed.
Even though you have already cleaned the
filter (before the POWER button was pressed),
the CLEAN LINT FILTER message will still be
displayed until the START button is activated.
GEAppliances.com
7