GE Profile PFDS450 Owner's Manual & Installation Instructions page 35

REVERSING THE DOOR SWING (if desired)
BEFORE YOU START
Unplug the dryer from its electrical outlet.
REMOVE THE DOOR ASSEMBLY
1
Remove the side hinge cap by opening the dryer
door and removing the screw from behind the
hinge (#8 x .375" tapping screw). Then using your
hand, pop the hinge cap off the dryer.
1 x C Screw
Downloaded from www.Manualslib.com
Installation Instructions
manuals search engine
REMOVE THE DOOR ASSEMBLY (cont.)
1
Close and hold the door, remove the 2 hinge screws
(#10 x 0.75" tapping screws). Pull the door away
from the dryer front panel.
DISASSEMBLE THE DOOR ASSEMBLY
2
Lay the door down on a soft, protected, flat surface
so that the inner part faces upward (door resting on
the handle side).
Remove the 7 screws (#10 x 1.125" tapping screws)
located around the perimeter of the door.
Hinge
cap
Turn the door assembly over and separate the
chrome cover from the inner door. Put the inner
door aside on a soft, protected flat surface.
35
2 x B
Screws
7 x A Screws