GE Profile PFDS450 Owner's Manual & Installation Instructions page 45

INSTALLING THE PEDESTAL (if desired) (cont.)
4 LEVEL THE WASHER OR DRYER
Stand the washer or dryer upright. Move it
A
close to its final location.
Make sure that the washer or dryer is level by
B
placing a level on top. Check side to side and
front to back.
Use an open
C
ended wrench
to adjust the
legs in and out.
Tighten
lock nut against
the bottom of
the pedestal.
NOTE: To minimize vibration, the locking nuts must
be tight.
5 REINSTALL THE DRAWER
Check to be sure the slides are closed.
A
Slide the drawer
B
into the
opening. Align
the drawer
supports to the
slides on each
side.
Reinstall the
C
original screws
into each
drawer slide.
Tighten both
screws.
Open the drawer fully. Slide drawer divider
D
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.
Downloaded from www.Manualslib.com
Installation Instructions
the
manuals search engine
6 REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side of the
washer.
7 FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation Instructions
to complete the installation.
Drawer
Divider
45