Back Band, Standard; Back, Ortoflex; Backrest With 30° Angle Adjustment - Ortopedia Impuls-System Operating Manual

3.3.2.2 Back band, standard

The standard back cover (Fig. 6) is
stretched into position by the rear tubes
when the wheelchair is unfolded.
The extended back section (Fig. 9/
is fastened below the seat area.

3.3.2.3 Back, ORTOFLEX

The tension of the back band can be
adjusted by means of Velcro strips (Fig.
9/ ).
The ORTOFLEX pad is fastened to the
adjustable back band section using
Velcro strips.
The extended back section (Fig. 9/
is fastened below the seat area.
22
ORTOFLEX
Standard
pad
back cover
)
ORTOFLEX
Standard
back band section
seat cover
9
)
3.3.2.4 Backrest with 30° angle
adjustment
For variable adjustment up to 30°, pull
the release levers (Fig. 9.1/ ).
Note:
Set both rear tubes to the same posi-
tion when the seat is occupied.
Pistons should be kept clean and
lightly greased with Vaseline (Fig.
9.2) for lasting performance.
Warning:
! Adjusting the angle increases the
danger of tipping over and should
only be undertaken if stabilisers are
fitted!
1
1
9.1
9.2
23