Table of Contents
Advertisement
Chapter 2 Preparations
1.13.3
Installation
Install a riser card to a PCI card in the following procedure.
[Installing RAID Controller card in slot PCI #1A]
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
1.
2.
Remove the screw securing the rise
card. Hold the both ends of the riser
card and lift it off.
Confirm the installation position with the reference to the table in (1.13.2 Supported cards and
3.
available slots).
4.
Remove the screw, and remove RAID
Controller bracket from the rise card.
Important
When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
• Check the card type (low profile or full-height type) which respective riser card
Note
supports and the type of PCI card to be installed.
• To install an extra battery for RAID Controller, refer to Chapter 2 (1.11 Extra
Battery for RAID Controller).
Note
Be careful not to contact with other parts.
Note
Keep the slot cover for future use.
Express5800/R120d-2E User's Guide
1. Installing Internal Optional Devices
Screws
Screw
RAID Controlller bracket
79
Advertisement
Table of Contents
