Cases That Require Configuration - NEC R120d-2E User Manual

Chapter 3 Setup
2.4

Cases that Require Configuration

Only if a case applies to any of following cases, use the SETUP utility to change a parameter which was
configured as factory setting. Other than cases described below, do not change the settings. A list of SETUP
parameters and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category Description
Basic Change date and time
On NumLock at power ON
Off the function to display the
logo during POST
Memory Memory configure after add or
change DIMM
Use memory RAS feature
Optional Disable Option ROM Scan of
board installed option board
Boot Change the boot order of
devices
Use remote power on feature
(via modem)
Use remote power on feature
(via RTC alarm)
Use console redirection feature Advanced → Serial Port Configuration
Security Set a password to restrict
operation of SETUP Utility
Set a password to restrict Boot
UPS When the server is supplied
Powerlink with power from UPS, always
turn on the power.
If it is turned off by using
POWER switch, leave it OFF
even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
Setting of parameter
Configure date and time
Main → System Date
Main → System Time
Boot → Bootup Numlock State → On
Boot → Quite Boot → Disabled
Advanced → Memory Configuration →
Memory Retest → Yes
Change to RAS mode
Advanced → Memory Configuration →
Memory RAS Mode
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → PCIXX Slot Option ROM →
Enabled
Change the boot priority
Boot → Boot Option Priorities
Advanced → Advanced Chipset
Configuration → Wake On Ring →
Enabled
Advanced → Advanced Chipset
Configuration → Wake On RTC Alarm
→ Enabled
→ Console Redirection Setting →
Change respective setting.
Set a password
Security → Administrator Password
Security → User Password
Security → Password On Boot →
Enabled
Server → Power Control
Configuration → AC-LINK → Power
On
Server → Power Control
Configuration → AC-LINK → Last
State
Server → Power Control
Configuration → AC-LINK → Stay off
Express5800/R120d-2E User's Guide
2. System BIOS Setup
Remark
Configurable on OS
By pressing the <Esc> key,
prevent the display of the logo.
After rebooting, Memory Retest
changes No automatically.
You can select Mirroring, Lock
Step, or Sparing.
XX is PCI slot number of the
option board
When you use
EXPRESSBUILDER, set
CD/DVD to the highest priority.
If password is set, a
message to enter password
is displayed at next time
SETUP is launched.
You can select this parameter
after you set password.
139