Table of Contents
Advertisement
Chapter 2 Preparations
(1)
When using the optional controller (N8103-149/150/151)
For details, refer to the manual that comes with optional RAID Controller (N8103-149/150/151).
[Installing optional PCI card in slot PCI #1B, 2B, 3B, 1C, or 2C]
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations..
1.
2.
Remove the three screw securing the rise
card B. Hold the both ends of the riser
card B and lift it straight to remove.
Confirm the installation position with the reference to the table in (1.13.2 Supported cards and available
3.
slots).
4.
Remove the blank cover from the rise card
(common to PCI slots #1B to 3B, 1C, and
2C) .
82
Important
You must avoid static electricity to work with the procedure below. For
details, refer to Chapter 2 (1.2 Anti-static Measures).
• When installing an optional RAID Controller, start the BIOS Setup utility, select
Note
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
Note
Be careful not to contact with other parts.
Note
Keep the blank cover for future use.
Express5800/R120d-2E User's Guide
1. Installing Internal Optional Devices
Screws
①
②
Advertisement
Table of Contents
