Response CWD3 Installation And Operating Instructions Manual page 20

Motion Detection Sensitivity
Select RECORDER SETUP, press MENU to enter.
Use ▲▼ to select MOTION DETECTION SENSITIVITY section
Use ◄► to highlight camera for setup
Use ▲▼ to adjust sensitivity level: OFF / LV1 / LV2 / LV3 (LV3 is most sensitive)
Press ESC to save and exit
Format Memory Card
Select RECORDER SETUP, press MENU to enter
Use ▲▼ to select FORMAT STORAGE, press MENU to enter
Press MENU again to confirm and begin formatting memory card
Press ESC to exit
NOTE:
If a new memory card is used then it must be formatted first here before use.
Setup Masking Area
Select RECORDER SETUP, press MENU to enter.
Use ▲▼ to select MASKING AREA section
Use ◄► to highlight camera for setup, press MENU to enter
Use ◄► ▲▼ to highlight the grid for no motion detection in this area. Use MENU
key to mask/unmask grid(s). Movements taking place inside masked area will be
ignored.Use ◄►▲▼ to select another grid for setup or press ESC to save and exit
20