Login - Patton SmartNode 2290 Series User Manual

Leased-line extenders over ip

Hide thumbs Also See for SmartNode 2290 Series:

Table of Contents

SmartNode 2290 Series User Manual

Login

1. Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to dis-

play. Type the factory default login: administrator and leave the password empty. Press the Enter key after

the password prompt.

password: <Enter>

172.16.40.1>

2. After you have successfully logged in you are in the operator execution mode, indicated by > as command

line prompt. With the commands enable and configure you enter the configuration mode.

172.16.40.1>enable

172.16.40.1#configure

172.16.40.1(cfg)#

3. Enter the following commands for the first SmartNode 229x device in the pair:

Copy nvram:a-side-config startup-config

Copy running-config startup-config

4. Follow the same procedure for the other SmartNode 229x device in the pair:

Copy nvram:b-side-config startup-config

Copy running-config startup-config

Note

The configuration above is only a sample configuration that you may use as

an example. You should specify your own parameters such as your IP address

and other related parameters as required. For detailed information about

configuring and operating guidance, set up procedures, and troubleshooting,

refer to the SmartNode Series SmartWare Software Configuration Guide avail-

able online at www.patton.com/manuals.

5. Reboot both units and connect them back-to-back through their Ethernet 0/1 ports. Voice connections

will automatically be set up between the units.

The steps above will configure the IP addresses as well as the required configurations for voice connections.

Configure the IP address

4 • Getting started with the SmartNode

Table of Contents