Other Remote Start Features; Low Battery/Low Temp Automatic Starting; Turbo Timer Feature; Pit-Stop Feature - Excalibur RS-140-DP Operation Manual

Deluxe keyless entry & remote start
Table of Contents

Advertisement

Other Remote Start Features

LOw BaTTERy/LOw TEmP auTOmaTIC STaRTING

This feature will automatically start the engine should the vehicle battery drop
below 11 volts or the interior temperature drop to 15 (or 32) degrees fahrenheit. This
feature is very useful when the vehicle is parked for a long period of time in cold
climates. You must activate these features each time you park your car and wish to
use them.
• Turn the ignition switch "on", then "off" (engine not running), and within 7 seconds
press the valet switch twice. The system is now in low voltage start mode.
• To activate low temp starting, enter low voltage start mode as described above
but, within 5 seconds of entering low voltage mode, press the valet switch 1 time (15
degrees) or 2 times (32 degrees) within 5 seconds.
NOTE: When low temp start mode is activated, low voltage start is also activated.
These features will operate once every two hours until the ignition key is turned
"ON".

TuRBO TImER FEaTuRE

It is typically recommended that vehicles equipped with turbocharged engines
allow the engine to idle for after driving to cool the turbocharger. When this Installer
Programmable Feature is enabled, the system will automatically keep the engine
running as follows:
• With the engine running, hold the brake pedal and engage the parking brake.
When the brake pedal is released, the system will keep the engine running for the
programmed time (1, 2, or 3 minutes), and then automatically turn it off.
• Turbo Timer can be prevented from engaging, or "bypassed" if desired, by turning
the engine off before engaging the parking brake, or if it's already engaged, step on
the brake pedal to turn the engine off.

PIT-STOP FEaTuRE

This feature allows you to leave your engine running for making quick errands. To
use this feature, have the engine running normally from the ignition switch and your
foot off the brake pedal. Press the Valet Switch twice; the parking lights will flash.
Turn the key off and the engine will remain running for the programmed run time.
4

Advertisement

Table of Contents
loading

Table of Contents