Ethernet Pseudowire Setup; Figure 42 Advanced > Vpn Transport > Ethernet Pseudowire Setup; Table 30 Advanced > Vpn Transport > Ethernet Pseudowire Setup - ZyXEL Communications MAX-306M1 User Manual

Chapter 9 The VPN Transport Screens
Table 29 ADVANCED > VPN Transport > Ethernet Pseudowire (continued)
LABEL
Ingress
Egress
Pseudowire
Description
Action

9.4.1 Ethernet Pseudowire Setup

Click a pseudowire entry's Edit icon in the ADVANCED > VPN Transport >
Ethernet Pseudowire screen to set up or modify an Ethernet pseudowire's
configuration.
Figure 42 ADVANCED > VPN Transport > Ethernet Pseudowire Setup
The following table describes the labels in this screen.
Table 30 ADVANCED > VPN Transport > Ethernet Pseudowire Setup
LABEL
Active
MPLS VC Label
Ingress
Egress
106
DESCRIPTION
This is the MPLS virtual circuit label number for traffic coming
from the peer device.
This is the MPLS virtual circuit label number for traffic going to the
peer device.
This displays the information you previously entered describing
the pseudowire.
Click the Edit icon to set up an Ethernet pseudowire or alter the
configuration of an existing Ethernet pseudowire.
Click the Delete icon to remove an existing Ethernet pseudowire.
DESCRIPTION
Select this to enable the pseudowire. Deselect it to disable the
pseudowire.
Enter the VC ingress label number for this pseudowire. This must
be the egress label number of the peer device. This should not
be the ingress label number of any other Ethernet pseudowire
configured on the WiMAX Modem.
Enter the egress label number for this pseudowire. This must be
the ingress label of the peer device. This should not be the
egress label number of any other Ethernet pseudowire
configured on the WiMAX Modem.
User's Guide