ZyXEL Communications MAX-306M1 User Manual page 214

Chapter 18 The Remote Management Screens
Table 78 TOOLS > Remote Management > TR069
LABEL
Periodic Inform
Enable
Periodic
Inform
Interval
Periodic
Inform Time
Apply
Reset
214
DESCRIPTION
Select this to allow the WiMAX Modem to periodically connect to the
ACS and check for configuration updates.
If you do not enable this feature then the WiMAX Modem can only be
updated automatically when the ACS initiates contact with it and if you
selected the Active checkbox on this screen.
Enter the time interval (in seconds) at which the WiMAX Modem
connects to the auto-configuration server.
Enter a time interval that the WiMAX Modem will trigger a periodic
inform interval. This works in tandem with the Periodic Inform
Interval and is not mutually exclusive of it.
The Periodic Inform Time must be in the following format: yyyy-mm-
ddThh:mm:ss where yyyy is a four digit year ("2009"), mm is a two
digit month (01~12), dd is a two digit day (01~28), hh is a two-digit
hour in 24-hour format (01~24), mm is a two digit minutes value (01-
60) and ss is a two digit seconds value (01-60).
Note: You must separate the day information from the hour
information with a "T".
This feature gives the WiMAX Modem a baseline from which to begin
calculating when each periodic inform happens.
If the inform time is set for some point in the past, the WiMAX Modem
interpolates the inform interval forward to the current time and begins
its periodic inform at the appropriate time based on this interpolation.
If the inform time is set for some point in the future, then the WiMAX
Modem interpolates backwards to the current time and actually begins
at the appropriate time based on this interpolation.
Click to save your changes.
Click to restore your previously saved settings.
User's Guide