Installing The Logset; Installing The Horizontal Trim - Montigo C34-DV Installation Operation & Maintenance

Figure 23c. Removing the door.
Re-installing the door:
To re-install the door, tilt the top edge towards you and line up the tabs of
the bottom of the door with the slots on the fireplace. Place the tabs into
the slots, and tilt the top of the door back towards the fireplace as far as it
will go. Close the latches by hooking Part B onto the groove at the top of
the door and pushing Part A down completely.
Installing the Log Set
Installing the Logs:
The C34-DV is supplied with five ceramic fibre logs. Unpack the logs and
handle them very carefully.
1. Remove the door cover and the glass door.
2. Place the Back log onto the back log rest as shown below in figure
24a. The log has lip on the bottom which fits into the slot on the log rest.
3. Place the Front log onto the front log rest as shown in figure 24a.
Center the log from side to side, and push it against the back of
the log rest. Carefully push the log onto the metal spikes on the log rest.
4. Place the top logs in position as shown in figure 24b, place the
Log 'C'
centre log down first, then the right and left logs.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Log 'A'
Figure 24a. Positioning for the front and back logs.
Part No. XG0117C
Installation
Log 'B'
Log 'D'
Embers
Figure 24b.Proper log placement.
Cautions:
If logs are not placed properly, excessive sooting
will result.
The surface of the logs will crack due to the heat
from the flames. This is a normal occurance.
Installing the Trim & Baffle
The fireplace is shipped with 6 horizontal trim pieces (3 upper and 3
lower), which must be field-installed.
Install the trim by placing the top edge of the trim over to the retainer clips
on either side of the fireplace. Push the bottom edge firmly inwards and
the trim will snap on. (See figure 25) Install the upper trim pieces so that
the baffle is resting between the top and middle piece, as shown below.
The trim piece with the Montigo Emblem should be installed on the lower
middle clips with the emblem on the right side.
Figure 25. Installing the horizontal trim pieces.
C34-DV Gas Fireplace
Log 'E'
Flame Shaper
Page 13