Montigo C38-DV Installation & Operation Manual
  1. Manuals
  2. Brands
  3. Montigo Manuals
  4. Indoor Fireplace
  5. C38-DV
  6. Installation & operation manual
Montigo C38-DV Installation & Operation Manual

Montigo C38-DV Installation & Operation Manual

C-series
Hide thumbs Also See for C38-DV:
Table of Contents

Advertisement

Quick Links

See also: Instruction Manual , Operation & Installation Manual
Warning:
Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage. Refer to
this manual. For assistance or additional
information consult a qualified installer,
service agency or the gas supplier.
What To Do If You Smell Gas:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
For Your Safety:
Do not store or use gasoline
or other flammable vapors
and liquids in the vicinity of
this or any other appliance.
Installation
Operation &
Maintenance
C38-DV
Gas Fireplace
Check local codes
n
and
read
instructions prior to
installation.
Leave this manual
n
with the owner.
all

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C38-DV and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Montigo C38-DV

Summary of Contents for Montigo C38-DV

  • Page 1 Installation Operation & Maintenance C38-DV Gas Fireplace Warning: For Your Safety: Check local codes Improper installation, adjustment, Do not store or use gasoline read alteration, service or maintenance can or other flammable vapors instructions prior to cause injury or property damage. Refer to and liquids in the vicinity of this manual.

  • Page 2: Table Of Contents

    Thank You for choosing a Montigo C-Series Fireplace. About the C38 Fireplace: Introduction ................2 The C38-DV includes a 25,000 BTU dual burner with embers and a Installation five piece ceramic logset. This model is available in four versions. Installing the Fireplace Shell ........... 3 C38DT - Top Vent, Millivolt Pilot Installing the Gasline ............

  • Page 3: Installation

    These clearances apply to all dimensions except the framed opening, Top Vent models (C38-DT), the minimum clearance is 15". (Minimum where the clearance to combustibles is 0". The C38-DV clearances to 1" clearance must still be maintained around the vent pipes.)

  • Page 4: Installing The Gasline

    C38-DV fireplaces are certified for use with Montigo Premium Series minimum inlet gas supply pressure of 11" W.C. & a manifold pressure (5" / 8") venting components. The C38-DV Top Vent may be used of 10" W.C. Provision must also be made for a 1/8" N.P.T. plugged with Standard Series (4"/7") components on vertical vent runs only.
  • Page 5 C38-DV Gas Fireplace Installation Installing Terminations with Built-In Frames Installing Heat Guards over Terminations PTO-3F PTKOG Frame the termination opening to 11" x 11". Ensure that the two long mounting brackets are facing the bottom of the termination. (See inset). This will provide more...

  • Page 6: Top Vent Models With Horizontal Venting

    C38-DV Gas Fireplace Installation Top Vent Venting Runs Heat Shields For the C38-DV Top Vent, there are two types of installations: A) Through-The-Wall Installations and B) Vertical (Through-The-Roof) Due to high flue temperatures, heat shields are required on all Installations.

  • Page 7: Terminations

    C38-DV Gas Fireplace Installation Example 1: 150" max. For our shortest venting configuration use components A and F (see 30" max. Figure 9a). Termination Rigid Section Solid Sections PEL-90F/F Elbow Exterior Wall Flex Section Hearth Figure 9a. Typical Top Vent installation. If the 90° elbow is Figure 10.

  • Page 8: Top Vent Models With Vertical Venting

    C38-DV Gas Fireplace Installation B. Vertical (Through-The-Roof) Installations 5/8" with option for 4/7" Vertical rise >12' can be reduced Vertical Terminations must be installed: • minimum 2' (two feet) above the highest point where vent passes through the roof. •...

  • Page 9: Rear Vent Models

    Flue Collar Figure 17. Flex installation. Heat Shields Due to high flue temperatures, heat shields are required on all C38-DV installations (except those with vertical terminations) at the point where the venting connects to the termination. With the heat shield, vent clearances can be maintained at 1".
  • Page 10 B. Multi-Elbow Installations Installation Of Rear Vent DV For more diffiicult installation situations, the C38-DV Rear Vent may C38-DV Rear Vent versions are supplied with an PXT-20 (female/ be installed with two — 90° elbows and up to 15' of horizontal run. If female) section.

  • Page 11: Finishing Around The Fireplace

    This can cause Limit Wall Switch Switch melting, deformation, discoloration or premature failure of T.V. and radio components. Figure 21. Wiring for the C38-DV-I with Honeywell gas control and pilot. Part No. XG0118C Page 11...

  • Page 12: Removing And Installing The Door

    Installation Removing and Installing Wiring for the optional Fan Kit the Door All C38-DV fireplaces may be equipped with optional fan kits (Part Removing the Door: no. RFK1001, RFK1003, RFK1006 or RFK1007)for circulating heat into the living space. Remove the trim (as described on the next page) to access the door Installations in Canada which employ the fans must be electri- latches.

  • Page 13: Installing The Logset

    The surface of the logs will crack due to the heat from the flames. This is a normal occurance. Installing the Logs: The C38-DV is supplied with five ceramic fibre logs. Unpack the logs Installing the Trim & Baffle and handle them very carefully.

  • Page 14: Lighting Instructions

    C38-DV Gas Fireplace Operation - Model C38-DV C38-DV with Millivolt (Standing) Pilot For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
  • Page 15 C38-DV Gas Fireplace Operation - Model C38-DV-I C38-DV-I with Honeywell Electronic Ignition For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

  • Page 16: Operation

    Burner Adjustment Doors and logs can get very hot. Handle only when cool. The C38-DV (millivolt model only) is equipped with an adjustable burner, allowing you to raise or lower the flames. To adjust the flames, General locate the black knob marked 'Hi-Lo', in the centre of the gas control valve (See Figure 26).

  • Page 17: Troubleshooting

    C38-DV Gas Fireplace Maintenance Troubleshooting Gas Control Valve (C38-DV) C34-DV-I HONEYWELL SV 9500 /SV9600 Power Generator Troubleshooting Sequence Pilot Adjustment Screw NOTE: Before Troubleshooting, Familiarize Yourself With Wall Switch The Startup And Checkout Procedure. START INSET CHECK: · Turn Gas Supply off ·...

  • Page 18: Warranty

    The Warranty The Companies warrants the Montigo Gas Appliance to be free from defects in materials and workmanship at the time of manufacture. On the Montigo, there is a ten- year warranty on the firebox and its components, a five-year warranty on the main burner and pilot burner, and a one-year warranty on the gas control valve and fibre logs.

  • Page 19: Termination Locations

    C38-DV Gas Fireplace Appendix A - Termination Locations A = clearance to the termination frame above grade, veranda, porch, M = clearance to mechanical air supply inlet deck, or balcony [16 inches (41 cm) minimum] [*6 feet (1.8 m) minimum] N = †...
  • Page 20 XG0118C Rev. 00 - 04/03 Canadian Heating Products Inc. Montigo Del Ray Corp. Langley, BC V4W 4A1 Ferndale, WA 98248...

This manual is also suitable for:

C38dtC38drC38dt-iC38dr-i

Table of Contents