Figure 2.11: Power Contacts Of The Terminal Block - Advantech EKI-4524RI User Manual

EKI-4524ARI Power Input Wiring
1. Insert DC power wires into the contacts.
Pin 5: Negative
Pin 6: Positive
Pin 3 & 4: P-Fail Contacts
Pin 1 & 2: NC
2. Tighten the wire-clamp screws to prevent the wires from loosing.
•
Note
Use Copper Conductors Only, 60/75
•
The wire gauge for the terminal block should be in the range between
12~ 24 AWG.

Figure 2.11: Power Contacts of the Terminal Block

°
C, tightening to 5 lb-in.
15 Chapter2