Configuring Cos Settings; Configuring Dscp Settings - Cisco CVR100W Administration Manual

Configuring Quality of Service (QoS)

Configuring CoS Settings

Configuring CoS Settings
NOTE
STEP 1
STEP 2
STEP 3

Configuring DSCP Settings

NOTE
STEP 1
STEP 2
STEP 3
Cisco CVR100W Wireless-N 300M Router Administration Guide
You can map CoS priority settings to the traffic forwarding queue on the
CVR100W.
You first need to go to the QoS Port-Based Settings page by clicking the link on
this page to set the trust mode to CoS.
To map CoS priority settings to the traffic forwarding queue:
Choose QoS > CoS Settings.
For each CoS priority level in the CoS Settings table, choose a priority value from
the Traffic Forwarding Queue drop-down menu.
These values mark traffic types with higher or lower traffic priority depending on
the type of traffic.
Click Save.
To restore the default CoS settings, click Restore Default. Then, click Save.
You can use the DSCP Settings page to configure DSCP-to-QoS queue mapping.
You first need to go to the QoS Port-Based Settings page by clicking the link on
this page to set the trust mode to DSCP.
To configure DSCP-to-QoS queue mapping:
Choose QoS > DSCP Settings.
Choose whether to only list RFC values or to list all DSCP values in the DSCP
Settings table by clicking the relevant radio button.
For each DSCP value in the DSCP Settings table, choose a priority level from the
Queue drop-down menu.
6
89