Configuring Mac Filtering - Cisco CVR100W Administration Manual

Configuring Wireless Network
Configuring Basic Wireless Settings
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
STEP 1
STEP 2
STEP 3
STEP 4
Cisco CVR100W Wireless-N 300M Router Administration Guide
In the Select SSID field, choose the SSID for which to configure the security
settings.
From the Security Mode menu, choose one of the three WPA Enterprise options.
(WPA-Enterprise only) In the Encryption field, choose one of the following options:
• TKIP/AES: Choose TKIP/AES to ensure compatibility with older wireless
devices that may not support AES.
• AES: This option is more secure.
In the RADIUS Server field, enter the IP address of the RADIUS server.
In the RADIUS Port field, enter the port used to access the RADIUS server.
In the Shared Key field, enter an alphanumeric phrase (8 to 63 ASCII characters or
64 hexadecimal digits).
In the Key Renewal field, enter the duration of time (600 to 7200 seconds)
between key renewals. The default value is 3600.
Click Save to save your settings.
Click Back to go back to the Basic Settings page.

Configuring MAC Filtering

You can use MAC Filtering to permit or deny access to the wireless network based
on the MAC (hardware) address of the requesting device. For example, you can
enter the MAC addresses of a set of computers and only allow those computers to
access the network. You can configure MAC Filtering for each network or SSID.
To configure MAC filtering:
In the Wireless Table (Wireless > Basic Settings), check the network that you
want to configure.
Click Edit MAC Filtering. The Wireless MAC Filtering page appears.
In the SSID Name field, the SSID for which to configure the security settings is
displayed.
In the Wireless MAC Filtering field, check Enable to enable MAC Filtering for this
SSID.
3
59