Configuring Ipv6-To-Ipv4 Tunneling; Viewing Ipv6 Tunnel Status - Cisco CVR100W Administration Manual

Configuring Network
Configuring IPv6
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
Cisco CVR100W Wireless-N 300M Router Administration Guide
On the CVR100W, RIPng is disabled by default.
To configure RIPng:
Choose Networking > IPv6 Configuration > Routing (RIPng).
Check Enable.
Click Save.

Configuring IPv6-to-IPv4 Tunneling

IPv6-to-IPv4 tunneling (6-to-4 tunneling) allows IPv6 packets to be transmitted
over an IPv4 network. 6to4 tunneling is typically used when a site or end user
wants to connect to the IPv6 Internet using the existing IPv4 network.
To configure 6to4 tunneling:
Select Networking > IPv6 Configuration > 6 to 4 Tunneling.
Check Enable.
Click Save.

Viewing IPv6 Tunnel Status

To view IPv6 tunnel status:
Choose Networking > IPv6 Configuration > IPv6 Tunnels Status.
Click Refresh to display the most up-to-date information.
This page displays information about the automatic tunnel set up through the
dedicated WAN interface. The table shows the name of tunnel and the IPv6
address that is created on the device.
2
46