Assembling The Mount - Cisco Aironet 1400 Series Hardware Installation Manual

Appendix D Assembling the Rooftop or Wall Mount

Assembling the Mount

Figure D-1
Figure D-1
1
2
To assemble the mount, follow the instructions below:
Place a washer on the long flanged hex bolt.
Step 1
Place the end of the mast pipe with the bolt holes into the mounting plate (see
Step 2
Align the holes in the mast pipe with the holes in the mounting plate.
Step 3
Insert the long flanged hex bolt and washer into the upper holes on the mounting plate and through the
Step 4
mast pipe (see
Place a washer and hex nut on the end of the long flanged hex bolt and hand-tighten.
Step 5
Position the mast pipe and mounting plate as shown in
Step 6
Align the lower square hole in the mast pipe with the semi-circular cut-out on the mounting plate.
Step 7
Step 8 Place the carriage bolt into the square hole on the inside of the mast pipe.
Step 9 Place a washer and hex nut on the end of the carriage bolt and hand-tighten.
Repeat Steps 8 and 9 for the other square hole.
Step 10
OL-4072-04
shows the correct locations for the three bolts.
Mount Bolt Locations
3
1
2
Long flanged hex bolt
Carriage bolt
Figure D-1).
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
3 Carriage bolt
Figure D-1.
Assembling the Mount
Figure D-1).
D-3