Bridge Leds - Cisco Aironet 1400 Series Hardware Installation Manual

Chapter 1 Overview

Bridge LEDs

Four LEDs are located on back of the housing to report installation and alignment conditions, bridge
status, radio activity, and Ethernet activity (see
Figure 1-2
1
2
3
The bridge LEDs are shown in
•
•
•
OL-4072-04
Bridge Connectors and LEDs
1
1
Power injector dual-coax ports
RSSI voltage port
Ethernet LED
The install LED indicates that installation mode is activated. During installation mode, the other
LEDs provide signal strength readings used for antenna alignment.
The radio LED blinks green to indicate radio traffic activity. The light is normally off, but it blinks
green whenever a packet is received or transmitted over the bridge radio link. This LED also
provides signal strength readings during installation mode.
The status LED signals bridge association status. Blinking green indicates that the bridge is not
associated with another bridge. Steady green indicates that the bridge is associated with at least one
other bridge. This LED also provides signal strength readings during installation mode.
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
Figure 1-2).
3
2
4 Status LED
5 Radio LED
6
Install LED
Figure 1-2.
5
4
Key Features
6
1-5