Cisco Aironet 1400 Series Hardware Installation Manual page 61

Chapter 6 Troubleshooting
Table 6-1
Ethernet
LED
Blinking
green
Blinking
amber
amber
—
—
—
—
Red
—
—
—
—
OL-4072-04
Bridge Normal Mode LED Indications (continued)
Status Radio
LED LED
— —
— —
— —
Blinking —
green
Green —
Blinking —
amber
Amber —
Amber Red
— Off
— Blinking
green
— Blinking
amber
— Amber
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
Meaning
Transmitting and receiving Ethernet packets.
Transmitting and receiving Ethernet errors.
Firmware error—disconnect and reconnect the power
injector power jack. If the problem continues, contact
technical support for assistance.
Root mode—no remote bridges are associated.
Non-root mode—not associated to the root bridge.
If all bridges are powered up, this could be caused by
incorrect SSID and security settings or improper antenna
alignment. You should check the SSID and security settings
of all bridges and verify antenna alignment.
If the problem continues, contact technical support for
assistance.
Root mode—associated to at least one remote bridge.
Non-root mode—associated to the root bridge.
This is normal operation.
General warning—disconnect and reconnect the power
injector power jack. If the problem continues, contact
technical support for assistance.
Loading firmware.
Loading Firmware error—disconnect and reconnect the
power injector power. If the problem continues, contact
technical support for assistance.
Normal operation.
Transmitting and receiving radio packets—normal
operation.
Maximum retries or buffer full occurred on the radio
interface—disconnect and reconnect the power injector
power jack. If the problem continues, contact technical
support for assistance.
Radio firmware error—disconnect and reconnect power
injector power.If the problem continues, contact technical
support for assistance.
Checking the Bridge LEDs
6-3