Bridge Brackets; Mast Bracket; Bridge Leds - Cisco Aironet 1400 Series Hardware Installation Manual

Chapter 3 Mounting and Alignment Overview

Bridge Brackets

The two bridge brackets mount on the back side of the bridge housing. Each bracket mounts on two
screw posts on opposite ends of the unit. The support pin on the bridge bracket must be facing the side
of the unit. These support pins are used to suspend the bridge in the notches on the mast mounting
bracket until you secure the mounting bolts.
The bridge brackets must be positioned to obtain the correct antenna polarization that matches the
remote antenna. The bridge housing contains an antenna polarization mark consisting of an arrow on the
side of the housing. When the bridge is positioned so that the arrow is pointing up, the bridge antenna is
vertically polarized. For horizontal polarization, the arrow should be pointing from left to right. All
bridges must use the same antenna polarization for best operation.

Mast Bracket

The mast bracket attaches to a mast or tower support and is used to secure the bridge.The procedure for
attaching the mounting bracket to the support depends on the pipe diameter, as shown in
Table 3-1
Mast Type
Roof mount,
small mast, or
tower
Large mast
The U-bolts supplied with the bridge support mast diameters up to 1.75 in. (44.5 mm). For larger masts,
Note
you must supply the U-bolts to attach the bridge.

Bridge LEDs

When you power up the bridge for the first time, it starts in a special installation mode. The LEDs
indicate the startup status, operating mode, association status, and received signal strength. This
information simplifies the process of activating the link and positioning the antenna from the bridge
mounting location.
The LEDs are mounted on the back of the housing near the connectors (see
OL-4072-04
Mast Bracket Attachment Methods
Mast Diameter
1.5 to 2.5 in.
(30.5 to 63.5 mm)
2.5 to 4.5 in.
(63.5 to115 mm)
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
Mast Attachment Method
Attach the pipe inside the mounting bracket, between the
bracket and bridge.
Attach the pipe outside the mounting bracket, away from
the bridge.

Bridge LEDs

Table 3-1.
Figure 3-1).
3-3