Antenna Alignment; Resetting To The Default Configuration; Using The Mode Button - Cisco Aironet 1400 Series Hardware Installation Manual

Antenna Alignment

Antenna Alignment

If your non-root bridges are unable to associate to your root bridge, you should verify the basic
configuration settings on all bridges before attempting to verify bridge antenna alignment (refer to
"Configuring the Bridge for the First Time" section on page
correct, you can verify antenna alignment by using the RSSI port. The RSSI port can be used even when
the bridges are not associated. For additional information, refer to the
RSSI Voltage" section on page
To meet regulatory restrictions, the external antenna bridge configuration and the external antenna must
Note
be professionally installed.
For detailed alignment instructions, refer to the Cisco Aironet 1400 Series Wireless Bridge Mounting
Instructions that shipped with your bridge.

Resetting to the Default Configuration

If you forget the password that allows you to configure the bridge, you may need to completely reset the
configuration. You can use the MODE button on the power injector or the web-browser interface.
The following steps reset all configuration settings to factory defaults, including passwords, WEP keys,
Note
the IP address, and the SSID.

Using the MODE Button

Follow these steps to delete the current configuration and return all bridge settings to factory defaults
using the MODE button:
Disconnect the power jack on the power injector.
Step 1
Press and hold the MODE button while you reconnect power to the power injector.
Step 2
Hold the MODE button until the Status LED turns amber (approximately 3 seconds).
Step 3
Step 4 After the bridge reboots, you must reconfigure the bridge by using the Web browser interface, the
Telnet interface, or IOS commands.
Note
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
6-8
3-6.
The bridge is configured with the factory default values including the IP address (set to receive
an IP address using DHCP). To obtain the bridge's new IP address, refer to the
Setup Utility" section on page
5-1). If your basic configuration settings are
5-9.
Chapter 6 Troubleshooting
"Aligning the Antenna Using the
"Using the IP
OL-4072-04