Articulating Mount For The Ap To A Wall Or Ceiling - Cisco C9124AXE-E Installation Manual

Table of Contents

Articulating Mount for the AP to a Wall or Ceiling

Materials Needed

10–mm box-end wrench

Outdoor rated shielded ethernet cable

Ground lug (provided with the access point)

Ground block and rod

Crimping tool for ground lug, Panduit CT-720 with CD-720-1 die

#6 AWG ground wire

Procedure

Step 1

Select a mounting location on the pole to mount the AP. You can attach the AP to a pole having a diameter

of 2 to 5 inch (51 to 127 mm).

Step 2

Hold the bracket up against the pole and slide the three-band straps through the top, middle, and bottom sets

of mounting slots on the mounting bracket.

Step 3

Wrap the band straps around the pole, lock them, and then lightly tighten the clamps using a wrench. Only

tighten them enough to keep the bracket from sliding down the pole

Step 4

Screw an M6 bolt into each of the four bolt holes on the backside of the AP. Do not screw the bolt in all the

way. Leave a gap of about 0.13 inch (3.3 mm).

Step 5

Position the four bolts on the AP into the bracket keyhole slots. Ensure that the AP is seated correctly in the

slots.

Note

Step 6

Using a 10–mm wrench, tighten the four bolts that connect the AP to the bracket to 40 lbf-in (4.5 Nm) of

torque.

Step 7

Mount the power supply to the bracket with four #8-32 screws.

Step 8

Locate the AP to its final position. Tighten the band clamps with the wrench. Ensure that the clamps are tight

enough not to let the AP move.

Step 9

Proceed to