Omron SYSDRIVE 3G3JV User Manual page 226

List of Parameters
Parame- Name
ter No.
(Register
No.
(Hex))
n60 Overtorque
detection lev-
(013C)
el
n61 Overtorque
detection time
(013D)
n62 UP/DOWN
command fre-
(013E)
quency
memory
n63 Torque com-
pensation
(013F)
gain
n64 Motor rated
slip
(0140)
n65 Motor no-load
current
(0141)
n66 Slip com-
pensation
(0142)
gain
n67 Slip com-
pensation
(0143)
time constant
n68 RS-422A/485
communica-
(0144)
tions time-
(See note
over detec-
3.)
tion selection
Description
Used to set overtorque detection level.
Set the level in percentage based on the rated cur-
rent of the Inverter as 100%.
Used to set the detection time of overtorque.
Used to store the adjusted frequency reference with
the UP/DOWN function.
0: Frequency not stored
1: Frequency stored
The frequency must be on hold for 5 s or more.
Used to store the adjusted frequency reference with
the UP/DOWN function.
0: Frequency not stored
1: Frequency stored
The frequency must be on hold for 5 s or more.
Used to store the adjusted frequency reference with
the UP/DOWN function.
0: Frequency not stored
1: Frequency stored
The frequency must be on hold for 5 s or more.
Used to set the gain of the torque compensation
function.
The default setting does not need any changes in
normal operation.
Used to set the rated slip value of the motor in use.
Note Used as the constant of the slip compensation
function.
Used to set the no-load current of the motor in use
based on the rated motor current as 100%.
Note Used as the constant of the slip compensation
function.
Used to set the gain of the slip compensation func-
tion.
Note The slip compensation function is disabled
with n66 set to 0.0.
Used for the response speed of the slip compensa-
tion function.
Note The default setting does not need any
changes in normal operation.
Used to set whether a communications time-over
(CE) is detected if there is an interval of more than 2
s, and to select the method of processing the
detected communications time-over.
0: Detects a time-over and fatal error and coasts to
a stop.
1: Detects a time-over and fatal error and deceler-
ates to a stop in deceleration time 1.
2: Detects a time-over and fatal error and deceler-
ates to a stop in deceleration time 2.
3: Detects a time-over and nonfatal error warning
and continues operating.
4: No time-over is detected.
Setting Unit of Default
range setting setting
30 to 1% 160
200
0.1 to 0.1 s 0.1
10.0
0, 1 1 0
0.0 to 0.1 1.0
2.5
0.0 to 0.1 Hz Varies
20.0 with the
capac-
ity.
0 to 99 1% Varies
with the
capac-
ity.
0.0 to 0.1 0.0
2.5
0.0 to 0.1 s 2.0
25.5
0 to 4 1 0
Chapter 10
Changes Refer-
during ence
operation page
No 6-9
No 6-10
No 6-19
Yes 6-11
Yes 6-12
No 6-12
Yes 6-12
No 6-12
No 7-5
10-11