10Sff (6 Nvme + 4 Sas/Sata) Express Bay Drive Backplane - HP ProLiant DL360 Gen9 User Manual

Connect the VGA/USB cable to the Front VGA/USB connector toward the rear of the system
board.
Install the access panel (on page 22).
8.
Slide the server into the rack.
9.
Connect all power cords to the server, and then power up the server.
10.
10SFF (6 NVMe + 4 SAS/SATA) Express Bay drive
backplane
The 10SFF (6 NVMe + 4 SAS/SATA) Express Bay Enablement Kit includes the following components:
•
8SFF Express Bay Drive Cage backplane
•
2SFF Express Bay Drive Cage backplane
•
2SFF Express Bay Drive Cage
•
Express Bay Bridge Card
This option provides support for up to six SFF NVMe SSDs and four SFF SAS drives, SATA drives, or
SSDs. The high-performance fans and a controller, such as the HPE Smart Array P440ar Controller, must
be installed when installing this option.
For more information about NVMe SSDs, see the Hewlett Packard Enterprise website
(http://www.hpe.com/support/NVMedrive_en). For more information on supported drives and
population rules, see the server user guide on the Hewlett Packard Enterprise website.
(http://www.hpe.com/support/DL360Gen9/docs)
To install the component:
Back up all server data.
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 21).
a.
Remove the server from the rack (on page 22).
b.
Hardware options installation 68