Advertisement
Chapter 5
Operating the Cisco ICS 7750
Saving Configuration Changes
Step 1
Step 2
Using Peripherals with SPE310s
78-14165-03
To prevent loss of the ASI or MRP configuration after a reboot, save the
running-config file to the startup-config file by following these steps:
Command
MRP> enable
Password: password
MRP#
MRP# copy running-config
startup-config
This section summarizes known issues and best practices regarding the use of
keyboards, mice, monitors, and the USB CD-ROM drive with SPE310s.
Consider the following issues when using peripherals with SPE310s:
USB CD-ROM drive:
•
The TEAC 210PU USB CD-ROM drive is included with the
–
Cisco ICS 7750. The TEAC 210PU USB CD-ROM drive is the only USB
CD-ROM drive that has been tested for use with SPE310s.
Do not connect or disconnect the USB CD-ROM drive while the SPE310
–
is booting. See the
section on page
USB keyboards, mice, and hubs:
•
Because the USB CD-ROM drive is required during reimaging, and
–
because the SPE310 has only two USB ports, a USB hub might be
required if you intend to connect both a USB keyboard and a USB mouse
to the SPE310, when the keyboard lacks a USB pass-through port.
For a list of USB keyboards, mice, and hubs that have been tested with
–
the Cisco ICS 7750, see the
Mouse to the SPE310" section on page
Purpose
Enters enable mode. You have entered enable
mode when the prompt changes to
Saves the configuration changes to the
startup-config file so that they are not lost during
resets, power cycles, or power outages.
"Best Practices for Using Peripherals with SPE310s"
5-20.
"Connecting a Monitor, Keyboard, and
Cisco ICS 7750 Installation and Configuration Guide
Accessing the System
MRP#
3-26.
.
5-19
Advertisement
