Advertisement
Backing Up System Data
f.
g.
Click Submit to start the backup.
Step 4
When the backup is complete, press Continue.
Step 5
The Backup History page appears, showing information about the backup.
Step 6
You must manually back up the Cisco IOS configuration files for the SSP and each
Flash-based MRP or ASI card (MRP300, MRP3-8FXS, MRP3-16FXS, or
MRP3-8FXOM1).
a.
b.
c.
Cisco ICS 7750 Installation and Configuration Guide
5-28
Password—The password that you use to gain access to the remote computer.
Domain Name—(optional) The domain name that you use to gain access to
your network (for example, MyCompany_Eng).
Enter the domain name carefully. Because of a limitation in Windows
Note
2000, even if you enter the wrong domain name, the backup will seem
to complete successfully.
Telnet to the MRP, ASI, or SSP card from the remote device (computer on the
network) where you stored your backup files in Step 3 above.
If the remote device (computer on the network) where you stored your
Note
backup files does not have Telnet access to the chassis cards, you may
save the backup configuration files on a PC that has Telnet access to
the chassis cards and then copy them to the remote device.
Enter the enable command and your Cisco IOS enable password to enter
privileged EXEC command mode:
Switch> enable
Password: password
Switch#
Enter the following command to display the startup configuration:
Switch# show startup-config
Chapter 5
Operating the Cisco ICS 7750
78-14165-03
Advertisement
