Advertisement
Accessing the System
Step 3
Step 4
Accessing Processor Cards Through the SAP
Step 1
Step 2
Cisco ICS 7750 Installation and Configuration Guide
5-12
Enter your login password.
Enter the show version command:
card> show version
The SAP provides console access to any other processor card in the
Cisco ICS 7750 chassis. By connecting your PC to the console port on the SAP,
or by dialing in to a modem that is connected to the console port, you can access
a menu that can help you debug and troubleshoot system cards.
To access this text-based menu, follow these steps:
If your PC is not already directly connected to the SAP console port, you can use
an RJ-45-to-DB-9 adapter with a rolled EIA/TIA-232 cable or the supplied
console (blue) cable to make the connection, as follows:
Connect the SAP console port to an available COM port on your PC.
•
Or
Connect a modem to the SAP console port to enable a dial-up connection
•
(9600 baud, maximum).
For instructions on how to connect the SAP directly to your PC, refer to
Note
the
"Connecting to Card Ports" section on page
how connect the SAP a modem and how to configure your modem for
remote dial-up access to System Manager, refer to the
Modem" section on page
On your PC, open HyperTerminal. On PCs running Windows 2000, a typical
HyperTerminal path is Start > Programs > Accessories > Communications >
HyperTerminal.
Chapter 5
4-39.
Operating the Cisco ICS 7750
3-18. For instructions on
"Connecting a
78-14165-03
Advertisement
