Table of Contents
Advertisement
How to Perform the Video Processing Module Initial Configuration
The network interface card settings screen appears as follows:
Enter a number between 0 and 5, inclusive, representing the required option.
Step 6
We recommend using 5 (Auto) and the ethernet switch port to autonegotiate speed/duplex.
Step 7
Press any other key to quit without changing the network working mode.
Step 8
At the prompt, enter 4 to disable the DSP reset facility.
After options Q and 1-3, press any key to return to the video processing module Main menu. After option
Note
4, the video processing module Main menu displays automatically.
Caution
Only qualified technical personnel should modify the DSP reset function settings.
Saving Network Configuration Settings
Modified network configuration settings are automatically saved when you exit the video processing
module Main menu.
Procedure
Ensure you have completed your configuration.
Step 1
At the prompt, enter Q to exit the video processing module Main menu.
Step 2
The video processing module Main menu closes and your machine will automatically reboot.
Connecting the EMP to the LAN
Procedure
Connect the supplied LAN cable from your network switch to the 10/100BaseT Ethernet port on the front
Step 1
panel of the EMP unit. The 10/100BaseT port accepts an RJ-45 connector.
We recommend setting the network switch port to auto-negotiate speed/duplex.
Turn on the power to the EMP unit.
Step 2
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7
2-12
Choose : 1 - 10Mbps
Half Duplex
: 2 - 100Mbps Half Duplex
: 3 - 10Mbps
Full Duplex
: 4 - 100Mbps Full Duplex
: 5 - Auto
other - Quit
:
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
OL-17012-01
Advertisement
Table of Contents
