Connections; Dmd15 Universal - Comtech EF Data Radyne RCS11 Installation And Operation Manual

RCS11 1:1 Redundancy Switch
PROPER GROUNDING PROTECTION: During installation and setup, the
user must ensure that the unit is properly grounded. The equipment
shall be connected to the protective earth connection through the end
use protective earth protection.
In addition, the IF input and output coax cable shielding must be properly
terminated to the Chassis/unit ground
4.6

Connections

This section provides data and frequency connections in a typical one for one installation.

4.6.1 DMD15 Universal

Figure 4-1 illustrates a 1:1 system using a RCS11 with the Universal Interface connected to
DMD15 Modems. Table 4-1 describes the connection hardware required.
Figure 4-1. RCS11 with Universal Interface Connected To DMD15 Modems
MN-RCS11 – Revision 9
WARNING
Installation
4–4