Power-Up Defaults - Comtech EF Data Radyne RCS11 Installation And Operation Manual

RCS11 1:1 Redundancy Switch
1.4

Power-Up Defaults

During power-up, the RCS11 initializes itself to the last mode set by the Front Panel Pushbuttons.
For example, if the operator desires the RCS11 to operate in the Auto Mode, with both the
Modulator and Demodulator set to Modem B, the operator places the RCS11 into this condition
using the Front Panel Pushbuttons and the RCS11 stores this configuration into nonvolatile
memory. If the power source was then to fail and be restored, the RCS11 would again power-up
in the Auto Mode with both the Modulator and Demodulator set to Modem B.
Universal with G.703 IBS/IDR Interface w/ 70/140 IF TX (used with DMD15/20/50)
Universal with G.703 IBS/IDR Interface w/L-Band IF (used with DMD15/20/50)
ASI Interface w/ 70/140 IF TX or RX only option (used with DM240XR or DD240XR)
ASI Interface w/ L-Band IF TX or RX only options (used with DM240XR or DD240XR)
Optional ASI Interface with Offline 70/140 IF Monitor (used with DM240XR)
Optional Parallel Interface (used with DM240XR or DD240XR)
MN-RCS11 – Revision 9
Introduction
1–2