Installation And Rear Panel; Installation Overview - Extron electronics IPL T PC1 User Manual

Installation and
Rear Panel
This section describes:
•
•
•

Installation Overview

To install and set up an IPL T PC1 interface:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Installation Overview
Rear Panels
Connecting Cables
Disconnect power from the PC1 interface and the output device (plasma display, VCR,
projector, and so forth).
If desired, mount the PC1 interface (see
Plug the PC1 power cord into an AC wall outlet.
Connect a LAN Ethernet cable from your computer to the RJ-45 port on the PC1 rear
panel to establish a link to the network (see
Port").
Set up an IP address for the PC1 (see
Programming and Control").
Plug an output device into the output power receptacle on the PC1 rear panel.
If desired, connect the output device to the serial COM port.
If desired, connect a contact closure device to the Input port.
If desired, connect an IR emitter to the IR port.
Press the front panel button to power on the receptacle.
Power on the output device.
Configure the PC1 interface using Global Configurator (provided on the included
software DVD) or the embedded web pages.
"Mounting the IPL T PC1
"Wiring the Local Area Network [LAN]
"HTML Configuration and
IPL T PC1 • Installation and Rear Panels
Interface").
Control" or "SIS
4