Setting Up And Configuring The Pc1 Using Arp - Extron electronics IPL T PC1 User Manual

Setting Up and Configuring the PC1 Using ARP

The Address Resolution Protocol (ARP) command provides a quick way to set up an IP
address for the PC1, using your PC. The ARP commands tell your computer to associate the
PC1 Media Access Control (MAC) address with an IP address that you assign.
1. Obtain a valid IP address for your PC1 from your network administrator.
2.
Obtain the PC1 MAC address (UID#) from the small label on the PC1 rear panel (see
"Rear
have the following format:
00-05-A6-nn-nn-nn
3. If the PC1 has never been configured and is still set for factory defaults, skip to step 4. If
not, perform a mode 4 system reset to restore the factory-set values (see "Resetting" in
the "Front Panel Features and Operations" section for the resetting procedure.)
CAUTION: The PC1 must be configured with the factory default IP address
4. On the computer, access the command prompt as follows:
a.
From your Windows desktop
b.
On the Run window, enter
5. At the command prompt enter
PC1, a space, and finally the PC1 MAC address (taken from the small label on the rear
panel; see
For example:
arp -s 10.13.197.57 00-05-A6-01-33-0D
A space must separate
Figure 10.
6.
Execute a ping command by entering
command prompt. For example:
ping 10.13.197.57
Ping is a utility or diagnostic tool that tests network connections. It is used to determine
if the host has an operating connection and is able to exchange information with
another host.
Panels" in the "Installation and Rear Panels" section). The MAC address should
(192.168.254.254) before you execute the ARP command, as described
below.
Start
cmd
arp -s
"Rear Panels" in the "Installation and Rear Panels" section).
and the hyphen [
arp
ARP-S Command Screen
menu, select .
Run...
. The command window opens.
, followed by the desired new IP address for the
].
-
, followed by the new IP address, at the
ping
IPL T PC1 • HTML Configuration and Control 16